Subject:
|
Re: New part (in progress): 6085
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 29 Jun 2000 12:56:41 GMT
|
Viewed:
|
1195 times
|
| |
|
|
In lugnet.cad.dat.parts, Bram Lambrecht wrote:
> Today's progress... Still need to do the inside of the front bit and some
> other sections. I'm also not sure how to do the base of the frontmost studs
> of the 2x2 section. The slope changes at a point more than halfway through
> the cylinder. Is there a way to do this with primitives or will I have to
> inline and chop away?
It's looking good, Bram!
Unfortunately, to be exactly accurate, all you can do is to inline and chop
away. Depending on how sharp the angle is, you can try the 1-4cyls.dat
and 1-4cyls2.dat primitives, to see how they fit. But they won't be
accurate.
Make sure you stretch the stud2a.dat's down to the point of intersection
with the front wall. That'll minimize the inlined area.
Steve
|
|
Message is in Reply To:
 | | Re: New part (in progress): 6085 [DAT]
|
| Today's progress... Still need to do the inside of the front bit and some other sections. I'm also not sure how to do the base of the frontmost studs of the 2x2 section. The slope changes at a point more than halfway through the cylinder. Is there a (...) (24 years ago, 28-Jun-00, to lugnet.cad.dat.parts)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
