Subject:
|
Re: [part] mockup/for-post of 30407
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sat, 5 Jun 1999 00:58:07 GMT
|
Viewed:
|
1003 times
|
| |
|
|
John VanZwieten <john_vanzwieten@msn.com> wrote in message
news:FCtvCC.6o8@lugnet.com...
> Looks good, though I would suggest inlining unofficial subparts when
posting
Oops. Sorry.
> parts. Swh1.dat is the correct subpart for this. I wrote swh4.dat
> specifically for the cockpit, since half the hinge is thinner at one end.
>
> -John Van
I just used the one that looked right.
BTW, how did you create these parts? They look soooooo good. Beautiful
work.
|
|
Message has 1 Reply:
 | | Re: [part] mockup/for-post of 30407
|
| (...) They provided a good challenge to be sure. The two-fingered parts involved lots of trig, while the one fingered part took plenty of trial and error. Modeling the area where the "nubs" on the two fingers slip into the indentions on the (...) (25 years ago, 6-Jun-99, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: [part] mockup/for-post of 30407
|
| (...) Looks good, though I would suggest inlining unofficial subparts when posting parts. Swh1.dat is the correct subpart for this. I wrote swh4.dat specifically for the cockpit, since half the hinge is thinner at one end. -John Van (25 years ago, 5-Jun-99, to lugnet.cad.dat.parts)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
