| | Re: Question about "stickers"
|
|
(...) You make the sticker whatever size it actually is. If it's 40 LDU wide and extend to the edges then that's what you make. A sticker is just like any other part: it must be modelled as close to the real life part as possible (including size). (...) (19 years ago, 13-Aug-05, to lugnet.cad.dat.parts)
|
|
| | Re: Question about "stickers"
|
|
(...) Hi Mark, I agree with Tim. I don't think this should be a set standard, you should make the stickers a size that looks good. In your case, I think I prefer the 1LDU inset, but it's really up to you. The 0.25 LDU is just to try & make sure the (...) (19 years ago, 12-Aug-05, to lugnet.cad.dat.parts, FTX)
|
|
| | Re: Question about "stickers"
|
|
I am also not on the LSC but I think that Tim's remarks make a lot of sense. (19 years ago, 12-Aug-05, to lugnet.cad.dat.parts)
|
|
| | Re: Question about "stickers"
|
|
(...) --SNIP PIC-- Hi Mark, I would assume that if it is a user created sticker you can put it where you want. For official stickers I assume you make them the same size as the original sticker. Which sort do you mean? I suspect the 0.25 LDU is (...) (19 years ago, 12-Aug-05, to lugnet.cad.dat.parts)
|
|
| | Question about "stickers"
|
|
So far, the only standard I've found about modeling sticker "parts" is that they should be 0.25 LU off the surface of the piece they will be "stickered" to. What about width & length compared to the surface? I.E: sticker for shields - should they (...) (19 years ago, 12-Aug-05, to lugnet.cad.dat.parts, FTX)
|
|
| | Re: have these pieces been CADed?
|
|
(...) It's worth noting that the parts aren't certified yet, and in fact have a hold vote in their common sub-file. So if the next official update is soon, then it's probably unlikely that these parts will be in it. --Travis (19 years ago, 29-Jul-05, to lugnet.cad.dat.parts, FTX)
|
|
| | Re: have these pieces been CADed?
|
|
(...) No, the primary PT admin (Chris Dee) has been off on holiday until recently. -Orion (19 years ago, 29-Jul-05, to lugnet.cad.dat.parts, FTX)
|
|
| | Re: have these pieces been CADed?
|
|
Let's just hope that not too much time and energy goes into this 'steering committee election thingy... (URL) (19 years ago, 29-Jul-05, to lugnet.cad.dat.parts, FTX)
|
|
| | Re: have these pieces been CADed?
|
|
(...) Read this: (URL) Niels (19 years ago, 29-Jul-05, to lugnet.cad.dat.parts, FTX)
|
|
| | Re: have these pieces been CADed?
|
|
(...) (URL) good right link>. (URL) good left link> (...) thanks! any idea when they'll be official? i figured they were by now & i just didn't get the update. also, any idea when the next official update will be on Ldraw? Jeff (19 years ago, 29-Jul-05, to lugnet.cad.dat.parts, FTX)
|