 | | Re: looking for 2 x 4 low angle slope part
|
|
(...) question has been in the "being voted on" stage for several months now. -- Jonathan Wilson wilsonj@xoommail.com (URL) (25 years ago, 15-Oct-99, to lugnet.cad.dat.parts, lugnet.admin.general)
|
| |
| | Re: looking for 2 x 4 low angle slope part
|
|
(...) And you were doing so good Jonathan. How things can so quickly revert to the ways of the past. I hope this was just a temporary slip back into your rude ways of the past. I will let Terry tell you how much offense you have wrought. Eric (...) (25 years ago, 15-Oct-99, to lugnet.cad.dat.parts, lugnet.admin.general)
|
| |
| | Re: looking for 2 x 4 low angle slope part
|
|
(...) I didn't thnk it is... I distinctly remember that it missed the boat on the first batch of starwars parts and is currently waiting for terry to get his act into gear and release the next batch, with the starwars engine and the patterned (...) (25 years ago, 14-Oct-99, to lugnet.cad.dat.parts)
|
| |
| | Re: looking for 2 x 4 low angle slope part
|
|
Part number 30363--yes, it's official. Friendly reminder: Please reserve the cad.dat.* newsgroups for .dat content posts or followups to .dat posts. Questions concernings parts, models, etc., may be posted to lugnet.cad. -John Van Patrick Justison (...) (25 years ago, 14-Oct-99, to lugnet.cad.dat.parts)
|
| |
| | Minifigure Torso Generator [DAT]
|
|
I have the developed a small program that can generate Minifigure torsos based on a bitmap of the original body. The program generates the dat but since the algorithm is a little but rough the files are a little bigger than regular torsos but I can (...) (25 years ago, 14-Oct-99, to lugnet.cad.dat.parts)
|
