| | Re: 6246f: Minifig Oilcan
|
|
[followups set to lugnet.cad.dev] Nice job! Now I don't have to worry about that entry on the Parts Tracker anymore. :) The power drill could be modified. I doubt it's seen much use. Especially not in situations where the position is (...) (25 years ago, 14-Jul-99, to lugnet.cad.dat.parts, lugnet.cad.dev)
|
|
| | Re: My first part
|
|
(...) If there are two different patterns, then the ?? will be replaced with two different two-digit numbers. Just like we've always done. Steve (25 years ago, 14-Jul-99, to lugnet.cad.dat.parts)
|
|
| | technic engine piston square 2x2 [DAT]
|
|
Hi, I'm not sure about the name, number and description and not about the lines in combination with the rounded edges. Any comments and or suggestions? Bart Titulaer 0 technic engine piston square 2x2 0 Name: pistonSQR.DAT 0 Author: Bart Titulaer 0 (...) (25 years ago, 14-Jul-99, to lugnet.cad.dat.parts)
|
|
| | tapbase also [DAT]
|
|
nothing changed, but I'm not sure wether it's already available on lugnet.com 0 Homemaker Tap Base 0 Name: tapbase.dat 0 Author: Tore Eriksson 0 Un-official Part 4 16 -20 0 -10 20 0 -10 16 0 -6 -16 0 -6 4 16 -20 0 10 20 0 10 16 0 6 -16 0 6 4 16 -20 (...) (25 years ago, 14-Jul-99, to lugnet.cad.dat.parts)
|
|
| | tap part number [DAT]
|
|
Hi, Jonathan send me yesterday this unofficial part, I've completed it. Tore Eriksson was and is the author (I should have asked you, but I saw it yesterday evening after I had finished it. I thought Jonathan was the original author), I think the (...) (25 years ago, 14-Jul-99, to lugnet.cad.dat.parts)
|