| | 3068p101 Tile 2 x 2 w/ SW Rebel mechanical pattern [DAT]
|
|
I had to enlarge this to 300% in LDLite/LDraw to make it look like it should, but in POV-Ray it turns out very nice. The Rebel insignia is an inlined subfile which I'd happily make available to anyone else doing SW parts, especially if a certain (...) (25 years ago, 28-Jun-99, to lugnet.cad.dat.parts)
|
|
| | Re: Repost: 30360 Cylider 3 x 6 x 2 2/3 Horizontal w/ cutout (SW Engine)
|
|
The roadsign is on my to-do list, if I can ever remember to bring the darn part to work. It will only take 15 minutes to do. -John Van Jonathan Wilson <wilsonj@xoommail.com> wrote in message news:376FA551.BDA80F...ail.com... (...) every (...) (25 years ago, 23-Jun-99, to lugnet.cad.dat.parts)
|
|
| | Re: Repost: 30360 Cylider 3 x 6 x 2 2/3 Horizontal w/ cutout (SW Engine)
|
|
no. i did want the "at-at foot" piece. if you look at lugnet.cad.dat.parts you will see that there is already a mock-up of the tie canopy there. (25 years ago, 22-Jun-99, to lugnet.cad.dat.parts)
|
|
| | Re: Repost: 30360 Cylider 3 x 6 x 2 2/3 Horizontal w/ cutout (SW Engine)
|
|
thanks... now all i need is the roadsign and the 1 x 2 with clip and i have every sw part of importance... (25 years ago, 22-Jun-99, to lugnet.cad.dat.parts)
|
|
| | Re: Repost: 30360 Cylider 3 x 6 x 2 2/3 Horizontal w/ cutout (SW Engine)
|
|
(...) I think he means the TIE canopy. Jeff (25 years ago, 22-Jun-99, to lugnet.cad.dat.parts)
|