Subject:
|
Re: repost of: ATV with rubber band suspension
|
Newsgroups:
|
lugnet.cad.dat.models
|
Date:
|
Thu, 29 Jul 1999 17:29:24 GMT
|
Viewed:
|
959 times
|
| |
|
|
Very neat little model. Blake, sometimes it takes time for
people
to get around looking at models, so don't be upset if you don't
get
any comments right away or at all. It doesn't mean that people
don't like your model, but that they either don't have the time
or
just forget to reply. Many of the people on Lugnet read many
of the groups, so they have a lot of messages to go through.
Again, very nice model. :)
Ryan
*********** REPLY SEPARATOR ***********
On 7/29/99, at 1:14 PM, Blake Christopher Gettig wrote:
> I posted this a while ago but nobody responded. I know it's • not much to look
> at but, it's great to what I can do if you build it.
>
> I built this model last year and decided to post it. I put • orthodontic rubber
> bands between the 1x1 plates with light holders to give the • pivoting chassis
> some resistance. The result was a simple suspension system • that works great
> for uneven terrain. In order for the suspension to work though • you need to
> apply slight pressure while rolling over varied terrain. If • you are
> interrested in building it, I highly recommend using a gray • technic pin to hold
> the chassis together or else the suspension will not work • properly. I'll be
> interested in hearing your comments!
> -Blake
>
> Note: since I exported it from LeoCAD the veiws aren't exactly • lined up right.
> Sorry.
>
>
|
|
Message has 2 Replies:
 | | Re: repost of: ATV with rubber band suspension
|
| (...) ryan makes a good point about not getting responses, blake. there can be lots of other reasons that people don't respond, but don't let that (or the occasional non-constructive criticism) stop you from posting your ideas. you did a nice job (...) (25 years ago, 29-Jul-99, to lugnet.cad.dat.models)
|
Message is in Reply To:
| | repost of: ATV with rubber band suspension [DAT]
|
| I posted this a while ago but nobody responded. I know it's not much to look at but, it's great to what I can do if you build it. I built this model last year and decided to post it. I put orthodontic rubber bands between the 1x1 plates with light (...) (25 years ago, 29-Jul-99, to lugnet.cad.dat.models)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
