Special:
|
[DAT] (requires LDraw-compatible viewer)
|
Subject:
|
custom steering/suspension joint assembly
|
Newsgroups:
|
lugnet.cad.dat.ideas
|
Date:
|
Sat, 17 Nov 2001 13:55:12 GMT
|
Viewed:
|
5505 times
|
| |
|
|
This is the .dat file of the custom assembly I used in my 4WD ute.
The axle went through the single hole at the front.
The towballs connected to the a-arm pieces from sets like 8880, 8848 etc
etc.
The steering (flex system in my case) connected to the #3 liftarm, there
was a 3/4 pin stuck into that then the flex connector was attatched to
the 3/4 pin.
Basicly, this allows an axle to have both drive power and steering
without needing special parts like on the 8880 or 8865.
0 Steering Joint
0 Author: Jonathan Wilson
1 0 0 0 0 1 0 0 0 1 0 0 0 1 32184.DAT
1 0 20 -20 20 1 0 0 0 0.00 -1 0 1 0.00 32184.DAT
1 0 -20 -20 20 1 0 0 0 0.00 -1 0 1 0.00 32184.DAT
1 0 20 19 20 1 0 0 0 0.00 -1 0 1 0.00 32184.DAT
1 0 -20 19 20 1 0 0 0 0.00 -1 0 1 0.00 32184.DAT
1 0 0 19 0 1 0 0 0 1 0 0 0 1 4519.DAT
1 0 0 -20 0 1 0 0 0 1 0 0 0 1 4519.DAT
1 0 10 -20 40 1 0 0 0 1 0 0 0 1 3705.DAT
1 0 10 20 40 1 0 0 0 1 0 0 0 1 3705.DAT
1 0 34 -20 40 0 -1 0.00 0 0.00 1 -1 0 0 6632.DAT
1 0 1 -20 41 -1 0.00 0.00 0 0.00 -1 -0.00 -1 -0.00 6536.DAT
1 0 1 20 41 1 0 0 0 -0.00 1 0 -1 -0.00 6536.DAT
1 0 1 28 21 -0.00 1 0 -1 -0.00 0 0 0 1 50.DAT
1 0 1 -33 21 0.00 -1 0 1 0.00 0 0 0 1 50.DAT
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
