Subject:
|
Re: ldraw+complete=?
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 12 Jul 1999 18:55:45 GMT
|
Viewed:
|
772 times
|
| |
|
|
After you've done this, don't forget to run mklist.exe, so the parts will show
up in Ldraw.
Jeff
- "She attacked right in the middle of your monologue!"
In lugnet.cad, Steve Bliss writes:
> On Mon, 12 Jul 1999 07:39:35 GMT, Patricia Schempp <pschemp@clemson.edu>
> wrote:
>
> > if i have the ldraw program and the complete.exe parts, what other parts
> > updates do i need to get to be complete?
>
> You also need to get the last two updates James Jessiman published. Go to
> <http://www.ldraw.org/memorial/archive/official.html> and click thru either
> link to get to the download area. Download both LP97-13.EXE and
> LP97-14.EXE to your hard drive. Store them in the directory above LDraw
> (so if you have LDraw in c:\ldraw\, put the download files in c:\).
>
> You install these files the same way you installed the ldraw.exe and
> complete.exe files. The best way is to run them from a command prompt,
> adding a -y option on the end:
>
> c:\>lp97-13 -y
> c:\>lp97-14 -y
>
> After you install these files, you will need to re-install the complete.exe
> file, because complete.exe has updated versions of some of the files in the
> LP updates.
>
> HTH,
> Steve
|
|
Message is in Reply To:
 | | Re: ldraw+complete=?
|
| (...) You also need to get the last two updates James Jessiman published. Go to (URL) and click thru either link to get to the download area. Download both LP97-13.EXE and LP97-14.EXE to your hard drive. Store them in the directory above LDraw (so (...) (25 years ago, 12-Jul-99, to lugnet.cad)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
