Subject:
|
Re: Do these parts exist in LDRAW?
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 19 Oct 2009 20:38:40 GMT
|
Viewed:
|
10227 times
|
| |
|
|
In lugnet.cad, Eric Albrecht wrote:
> Also, when inserting the part in MLCAD, is there
> any obvious way to tell the difference?
>
> Eric
Nope, 50746.dat is merely an alias to 54200.dat and as such the parts appear
identical in MLCad (and in any other editor one might use). If I recall
correctly, it was something to do with the plastic used to mold the parts but
don't trust me.
|
|
Message has 1 Reply:
 | | Re: Do these parts exist in LDRAW?
|
| (...) You're spot-on Santeri. And the reason I said one might technically stick to the "correct" numbers is two-fold: on the off-off-off chance some renderer were to ever render based on the type of plastic (ABS versus polycarbonate), and also (...) (15 years ago, 20-Oct-09, to lugnet.cad)
|
Message is in Reply To:
| | Re: Do these parts exist in LDRAW?
|
| (...) What is the purpose of having two versions? I assume that the transparent version has all the internals accurately modeled so you can see them when light passes through, but why not just use this one even when it is opaque? I am obviously (...) (15 years ago, 19-Oct-09, to lugnet.cad)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
