| |
New in Version 1.2.x
At loading of a part DATHeader counts now the colors and listed the result on
the right side, so you can see which colors are used in your file.
If you know it should have only color 16 and 24 you can mark the file as
Uncolored and let DATHeader correct all wrong lines to: linetype 1,3,4 will set
to color 16 and linetype 2,5 will be set to color 24.
Also at loading the colors are checked against LDConfig.ldr and you will get a
notice which color are not in the LDConfig.ldr.
If you save the file there are additionally tests performed for correct colors..
It also could happen that the 'Name:' entry in the file does not match the real
filename. Also those parts are rejected by the PT.
Now there is a check also for this and an attempt to solve this problem in a
dialog system with the user.
The !HELP entry is now also supported.
There was also a bug for the description length if it was detected that a "~" or
a "_" has to be added and so the description was enlarged by one byte and that
exceeded what is accepted by the PT. This bug should be solved.
There was also a bug if you had typed the filename to open by hand, and that
file did not exists you got too many error messages. This bug should be solved.
I hope to finish DATHeader end of this week.
If you have any wishes what DATHeader should do for you, please let me know.
cu
mikeheide
|
|
Message has 1 Reply:
2 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
