Subject:
|
Highly confused about Library Updates for MLCad
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 16 Oct 2007 03:02:01 GMT
|
Viewed:
|
2339 times
|
| |
|
|
Hello everybody!
For years I have been using MLCad, and I am grateful for the great service and
support of the software. I recently installed the official parts updates for
MLCad offered at the relating website. But now suddenly I have 2 1x1 round
plates. The standard 4073 one and a new 6141. May I ask what is the need for
this second one?
Speaking of double parts, I have another question if I may. There is the 1x1x2/3
slope 50746 (http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/50746.dat). I
downloaded it when it first appeared. Today it is a subfile for a new part 54200
(http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/54200.dat), the identically
piece. But does this need its identical file as subfile? And, both are indicated
as 45 degree slopes although the slope is only roughly 30 degress.
Can anyone un-confuse me? Any help is greatly appreciated! Thank you very much,
yours Christopher
|
|
Message has 2 Replies:
 | | Re: Highly confused about Library Updates for MLCad
|
| (...) According to comments in my copy of the 6141 file, 0 // Part 6141 is the counterpart of 4073. Visually, the two parts seem 0 // identical. This file is provided to make it easier to locate part files 0 // when using the numbers used in LEGO (...) (17 years ago, 16-Oct-07, to lugnet.cad, FTX)
| | | Re: Highly confused about Library Updates for MLCad
|
| (...) Hello Christopher, I will not go into the same level of details as previous replies in this thread, but rather reply in a more general way. First of all, you make a mistake if you call it "Library Updates for MLCad". In one way, yes they are (...) (17 years ago, 17-Oct-07, to lugnet.cad)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
