Subject:
|
Re: LDView command line snapshot scaling
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 8 Jun 2007 00:42:10 GMT
|
Viewed:
|
7250 times
|
| |
|
|
In lugnet.cad, Travis Cobbs wrote:
> > Out of curiosity, do you anticipate a Mac binary of the beta will be available?
> > If so, I can wait for that. Otherwise, I probably will dust off my notes and
> > have a go at building the current code.
>
> I do plan to release a Mac binary of the Beta. In fact, I'll probably get that
> built and posted to sf.net before announcing it more officially and updating the
> LDView web page.
Neat!
Here's what I get with my quick attempt to try the examples with the current
code, built using the same Qt 3.3.7 I used for the alpha. The bricks appear
scaled correctly, but there are some large artifacts.
ldview -ModelSize=600 -AutoCrop=1 $LDRAWDIR/parts/3003.dat
-SaveSnapshot=3003-b.png -SaveActualSize=0 -SaveWidth=1024 -SaveHeight=1024
http://www.brickshelf.com/gallery/anoved/Examples/3003-b.png
ldview -ModelSize=600 -AutoCrop=1 $LDRAWDIR/parts/3005.dat
-SaveSnapshot=3005-b.png -SaveActualSize=0 -SaveWidth=1024 -SaveHeight=1024
http://www.brickshelf.com/gallery/anoved/Examples/3005-b.png
I'm not sure if that's due to a problem with my build procedure (such as it is,
./makeall basically) or what, but I'm content to wait for your beta.
Again, thanks for your response and the effort you put into LDView.
Jim
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: LDView command line snapshot scaling
|
| (...) It uses LDraw units. (...) I do plan to release a Mac binary of the Beta. In fact, I'll probably get that built and posted to sf.net before announcing it more officially and updating the LDView web page. --Travis (17 years ago, 8-Jun-07, to lugnet.cad)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
