Subject:
|
Re: Announcing Bitsticker
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 2 Mar 2007 00:04:28 GMT
|
Viewed:
|
2445 times
|
| |
|
|
In lugnet.cad, Travis Cobbs wrote:
| |
You might want to add the following two lines to the tops of your generated
files:
0 UNOFFICIAL PART
0 BFC CERTIFY CW
Adding the above two lines will enable BFC processing. The first line is
needed because most models don’t contain a 0 BFC CERTIFY line in them.
--Travis
|
No sooner said than done! Thank you for the suggestion. I figured it would be
good to wind the polygons consistently but I didn’t think to declare it with
BFC. Doing so is clearly beneficial.
Jim
|
|
Message is in Reply To:
 | | Re: Announcing Bitsticker
|
| You might want to add the following two lines to the tops of your generated files: 0 UNOFFICIAL PART 0 BFC CERTIFY CW Adding the above two lines will enable BFC processing. The first line is needed because most models don't contain a 0 BFC CERTIFY (...) (18 years ago, 1-Mar-07, to lugnet.cad, FTX)
|
18 Messages in This Thread:
 
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
