Subject:
|
Re: Error in the COLOUR meta command specification?
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sat, 12 Aug 2006 18:17:24 GMT
|
Viewed:
|
1890 times
|
| |
|
|
In lugnet.cad, Michael Lachmann wrote:
> I've just found out that there is an error in the specification. The point
> effected is the EDGE value.
> According to the specification it should be either a color code or an RGB value.
> Further on the specifications says an RGB value always has to be hex
> (identified by # or 0x) - fine.
>
> But it also states that: Numeric parameters, other than RGB color values,
> should be specified in decimal.
>
> This leaves a small risk for a misinterpretation, because that means a
> numeric parameter could also be hex.
No, if it is hex, then it is an RGB value and not a color code.
/Lars
|
|
Message is in Reply To:
 | | Error in the COLOUR meta command specification?
|
| Hi, I've just found out that there is an error in the specification. The point effected is the EDGE value. According to the specification it should be either a color code or an RGB value. Further on the specifications says an RGB value always has to (...) (18 years ago, 13-Jul-06, to lugnet.cad)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
