 | | Re: Callout in LPub —Kevin L. Clague
|
| | | (...) 0 // Idefinty part calledoutmodel.ldr 0 LPUB CALLOUT BEGIN 0 // Place the callout centered above the assembly 0 LPUB CALLOUT PLACEMENT TOP CENTER ASSEM 0 // Draw a pointer from right edge of callout to upper right of ASSEM 0 LPUB CALLOUT (...) (19 years ago, 30-May-05, to lugnet.cad)
|
| | | |
| | | | | Re: Callout in LPub —Jaco van der Molen
|
| | | | (...) OK! Nearly there: (URL) to eleminate the arrows in the assem (due to ghosting) and get rid of step 2 in the call out. Also the pointer is missing (something wrong with the code?) Here is the DAT code of the entire model: 0 FILE 1088.ldr 0 Set (...) (19 years ago, 31-May-05, to lugnet.cad)
|
| | | | |
| | | | | | Re: Callout in LPub —Philippe Hurbain
|
| | | | Hello Jaco, (...) Yes, getting better and better ! (...) Yes, CALLOUT POINTER takes 4 parameters, the side (RIGHT), the position on that side (missing here, 0.9 would be a good start) and the x-y position of the tip (0.8 0.3) Philo (19 years ago, 31-May-05, to lugnet.cad)
|
| | | | |
| | | | | | Re: Callout in LPub —Jaco van der Molen
|
| | | | (...) Right. That did it! Tnx. Jaco (19 years ago, 31-May-05, to lugnet.cad)
|
| | | | |
