Subject:
|
Re: Newbie L3PAO/POV-RAY Question
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 20 Feb 2004 11:57:41 GMT
|
Viewed:
|
1352 times
|
| |
|
|
In lugnet.cad, Ahui Herrera wrote:
| |
| |
| |
I tried installing a new copy of L3PAO and that didn’t change anything.
I tried installing a new copy of POV-RAY and that made the error message go
away, but it didn’t work right because it complained about an ‘A’ argument
in the command line to run POV-RAY. The only version of POV-RAY I could
find was v3.5 which seems to be later than the one included in the
all-in-one installer.
|
|
The all-in-one installer will install BOTH POV-Ray 3.1g and 3.5 if you select
custom install and choose to install MEGAPOV (it will also install POV-Ray
3.1g.) Likewsie you can find POV-Ray 3.1g here:
ftp://ftp.povray.org/pub/povray/Old-Versions/
| |
Don’t woory about this error. I’ve tried to fix this problem myself to no
avail. POV-Ray and L3PAO don’t seem to get along. Anyway, L3PAO works just
fine as you said and all you need to do is open the file L3P creates is to
double click the file you want to open.
-Orion
|
L3PAO DOES NOT recognize POV-Ray 3.5 ONLY 3.1g. All this means is that
L3PAO can not auto-render the converted files if you only have POV 3.5. But
like Orion stated you can always render the file in POV 3.5 if you open it up
from within POV.
|
I forgot to mention. If you are going to use POV 3.5, please read the following
article:
http://www.ldraw.org/article/105
-Orion
|
|
Message is in Reply To:
 | | Re: Newbie L3PAO/POV-RAY Question
|
| (...) The all-in-one installer will install BOTH POV-Ray 3.1g and 3.5 if you select custom install and choose to install MEGAPOV (it will also install POV-Ray 3.1g.) Likewsie you can find POV-Ray 3.1g here: <ftp://ftp.povray.or...Versions/> (...) (...) (21 years ago, 20-Feb-04, to lugnet.cad, FTX)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
