 | | ML-CAD 3.30 Problem while parts authoring
|
|
Hello Michael, I have a problem while parts authoring. When I have insert a new primitive and changing the first time it's values, like the size, evrything works fine. But when I want to change the size or so again. Then the "position & orientation" (...) (15 years ago, 16-Feb-10, to lugnet.cad.mlcad)
|
| |
| | Re: "Dither" colors in patterned/sticker parts
|
|
(...) But that's different from parts authors being able to use bump mapping in a part file. Or specific colors actually being implemented as bumps/textures -- so 'rubber black' actually looks distinct from 'black'. (15 years ago, 16-Feb-10, to lugnet.cad.dat.parts)
|
| |
| | Re: "Dither" colors in patterned/sticker parts
|
|
(...) I was under the impression that LDView already uses bump mapping for the stud logos. Is that wrong? (15 years ago, 16-Feb-10, to lugnet.cad.dat.parts)
|
| |
| | New Datsville Train Needed [DAT]
|
|
Who wants to contribute? The official LEGO Model rjwmetro.ldr has to be replaced by a MOC. It is desireable to make it fit to Rjjtofc.ldr by James Jackson; his model has been pending for years. See attached MPD file. By contributing to Datsville, (...) (15 years ago, 16-Feb-10, to lugnet.cad.dat.models)
|
| |
| | Re: "Dither" colors in patterned/sticker parts
|
|
(...) If I'm not mistaken, two big pushes were made for texture mapping, in 2004 and 2007. Both failed because of too much committee, too little action. This after previous attempts were made, of course, but looking at LUGNET, that's when the big (...) (15 years ago, 16-Feb-10, to lugnet.cad.dat.parts)
|
