 | | Re: POV Help Needed
|
|
(...) Hi Tore, This may not work but possibly you can use the fact the L3Studs will only exist in l3p V1.4. You could try using #ifdef as follows #ifdef (L3Studs) // Do V1.4 stuff #else // Do V1.3 stuff #end Is that what you were after? Tim (15 years ago, 12-Aug-09, to lugnet.cad.ray)
|
| |
| | POV Help Needed
|
|
Please see the question in my previous post: (URL) (15 years ago, 11-Aug-09, to lugnet.cad.ray)
|
| |
| | POV dat for L3P v1.4 - 3626bpse - Minifig Head with SW Scout Trooper Black Visor Pattern - POV [DAT]
|
|
Ok, so now I've found out why my minifig head dats with inline POV no longer work. New POV-Ray version was no problems this time. But two changes frm L3P 1.3 to 1.4 caused problems: The names of the colors have been changed from Color[n*] to (...) (15 years ago, 11-Aug-09, to lugnet.cad.ray, lugnet.cad.dat.parts)
|
| |
| | Re: New LDConfig.ldr color file
|
|
(...) I have a few comments here. First of all, if you're going to load a huge model in LDView, it's usually best to set its "Memory Usage" setting to Low (especially on old hardware). Secondly, as has been pointed out, LDView takes a lot longer to (...) (15 years ago, 11-Aug-09, to lugnet.cad.dev.org.ldraw, FTX)
|
| |
| | Re: New LDConfig.ldr color file
|
|
(...) Did you have any suggestions for him? I did not, other than that he does not have his paths set up correctly (which was already mentioned). I do not even have LPub 2 installed anywhere anymore. Do you? If so, maybe you could help him. I'd (...) (15 years ago, 11-Aug-09, to lugnet.cad.dev.org.ldraw)
|
