|
|
 | | Re: LSynth 3 available on kclague.net
|
| (...) So, tried to do a fresh install of more than just LSynth, and it now works like a charm! It helped to have the newest MLCAD *blush*. No idea on how I managed to still have 3.11 installed. Sorry guys! Cheers, Matija (16 years ago, 26-Mar-09, to lugnet.cad)
| | | | | Re: Is there an origin point specified in LDRAW parts?
|
| (...) Origin of all parts is x=0,y=0,z=0. Where this origin is placed at the part is different. Y-Direction: If the part have studs, then the y=0 is the surface below the studs. If the part has no studs, then it should be at the top of the part, or (...) (16 years ago, 25-Mar-09, to lugnet.cad)
| | | | | Re: Is there an origin point specified in LDRAW parts?
|
| (...) Well, the origin is simply the zero-point X=0;Y=0;Z=0 in all parts, no exceptions. The quads/triangles/line...itives/... are built around that origin. (16 years ago, 25-Mar-09, to lugnet.cad)
| | | | | Is there an origin point specified in LDRAW parts?
|
| If there is an origin point specified in LDRAW part files, I would like to know what is needed in order to calculate it's position and alignment to the x, y, z coordinate system LDRAW uses. Can anyone point me to where I can find information that (...) (16 years ago, 25-Mar-09, to lugnet.cad)
| | | | | Re: NXT based 3D scanner
|
| Hi Eric, (...) Sorry for the aspirin, that was not intended ;o) (...) Thanks! And yes, I am from Earth... Philo (16 years ago, 23-Mar-09, to lugnet.cad, lugnet.robotics)
|
|
