 | | 61409 - Slope Brick 18 2 x 1 x 2/3 Grille [DAT]
|
|
Hi all, Just whipped up this mockup for 61409 and thought I'd share it. I don't currently have the part handy and I wasn't sure if the little bump in the middle should be explicitly modelled but it serves as a pretty useful mockup for most models. (...) (16 years ago, 5-Sep-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Best practice for using unofficial parts?
|
|
(...) I am very sorry for that mistake has happen. I would like to help you in this case, but as long as I have no more detailed informations, I am unable to help. For translations I recommend (URL) to use. As far as I know the best translation tool (...) (16 years ago, 5-Sep-08, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: LPub and non callout sub parts used multiple times
|
|
(...) Yes, it does. I've fixed the ROTSTEP issue. I've also got the xN submodels thing fixed (with mirrored detection). I've tested it against your 5990.mpd you shared so long ago and it works. Something is very whacked though, because half the time (...) (16 years ago, 5-Sep-08, to lugnet.cad)
|
| |
| | Re: Best practice for using unofficial parts?
|
|
(...) I find German hard to read, but not at all impossible. And I don't think Swedish is much closer related to German than English is. Anyway, you can always make a screen dump and crop out the error messagebox. /Tore (16 years ago, 5-Sep-08, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Best practice for using unofficial parts?
|
|
(...) I downloaded tried to install MPDCenter from here: (URL) the installer is all in German, which I can't read, and I got an error message that I can't understand... I would copy/paste the error, but it doesn't allow me to select the text from (...) (16 years ago, 4-Sep-08, to lugnet.cad.dev.org.ldraw)
|
