 | | Re: Opinions sought on rendering method
|
|
(...) I think it's really good. Maybe you should ship LDView with an "instructions" preference set configured for this kind of output! Jim (19 years ago, 9-Oct-07, to lugnet.cad.ray, FTX)
|
| |
| | Re: Opinions sought on rendering method
|
|
Well, as of 0135 PDT, lugnet.cad.ray is at the top of the 24-hour column of the LUGNET Traffic Report (with 18 posts, vs. 12 for the next group). That makes me feel good. :-) (This is the only thread in the group that has had any posts in the last (...) (19 years ago, 9-Oct-07, to lugnet.cad.ray, FTX)
|
| |
| | Re: Opinions sought on rendering method
|
|
(...) OK, I played around with this tonight for a few hours, and finally came up with something that I think I'm happy with. It requires 3 passes of the transparent polygons (just during snapshot save with SaveAlpha enabled), but it seems to get (...) (19 years ago, 9-Oct-07, to lugnet.cad.ray, FTX)
|
| |
| | Re: Opinions sought on rendering method
|
|
(...) To me, the reasons are mainly "historical": the first way to get better images than the output of Ldraw/MLCad/LeoCAD (which is not that bad for instructions!) was POV-Ray. L3PAO then LPub did a lot to push POV as the renderer of choice. Add to (...) (19 years ago, 9-Oct-07, to lugnet.cad.ray, FTX)
|
| |
| | Re: Opinions sought on rendering method
|
|
(...) A very important point - I didn't even noticed that the vehicle roof was grey, not white! (...) That's the main problem of LDD generated instructions: no edges... Philo (19 years ago, 9-Oct-07, to lugnet.cad.ray, FTX)
|
