| | Re: Symmetries other than 16 and 48?
|
|
(...) For parts with unusual symmetries, I would suggest either (or both): 1. Make a subfile in parts\s with 1 segment of the part, then use that subfile as many times as you need. 2. Find a higher-level symmetry that is common with 16 or 48 (...) (21 years ago, 23-May-03, to lugnet.cad.dev)
|
|
| | [Parts Tracker] Notes for Admins
|
|
Just a quick note for authors & reviewers on the Parts Tracker -- if you need an admin to address something, please email parts@ldraw.org about it -- if you just leave a comment in a review, the admins will only pick up on it by chance. Actually, (...) (21 years ago, 23-May-03, to lugnet.cad.dev)
|
|
| | LeoCAM BETA RELEASE !!!
|
|
Hi all: After a couple of delays, I'm extremely proud to announce the release of the newer version of LeoCAM, the beta version. With this new implementation, you'll able to snap parts effortlessly just by clicking on their connectors. You'll even be (...) (21 years ago, 23-May-03, to lugnet.cad)
|
|
| | Re: Is anyone making part 44224.dat?
|
|
The mating part is refered to as 44225 on both Peeron and Bricklink... Philo (...) (21 years ago, 23-May-03, to lugnet.cad.dev, lugnet.cad.dat.parts)
|
|
| | Difficulties in LPub
|
|
Hi Kevin (and everyone else ofcourse), After a few trials and errors, I finally managed to get the parts in the Part List Images at the same scale. It turns out that I had to set the minimum distance to 50000 (!). Is this because a plate of 6x16 is (...) (21 years ago, 23-May-03, to lugnet.cad.ray)
|