 | | part(s) posted... (set #4817)
|
|
I went with pattern number "4f", since "4b" has been taken by some other torso. Minifig Hips & Legs with Leather Armor Pattern (Complete) (URL) Hips with Leather Belt (Red Studs) Pattern (URL) Leg Right with Leather Straps (Red Studs) Pattern (URL) (...) (23 years ago, 10-Apr-02, to lugnet.cad.dev)
|
| |
| | Re: Beta testers needed
|
|
I've created a temporary webpage for LD4DModeler, in time you can download the beta there. The url is: (URL) (23 years ago, 10-Apr-02, to lugnet.cad)
|
| |
| | Re: Parts as volumes (instead of surfaces)
|
|
(...) That was only bounding boxes (minus the studs). The piece in question was matched against all other pieces, any pieces in a line above or below were put into a list. In case one of them intersected the piece in question, a new place would be (...) (23 years ago, 10-Apr-02, to lugnet.cad.dev.org.ldraw)
|
| |
| | Enhancement request - File dialogs
|
|
I think the File dialogs could benefit from some improvement in how path is determined. This applies to at least export model and export submodels (in Multipart mode) Both default to the root of the C drive and don't remember last filepath selected. (...) (23 years ago, 10-Apr-02, to lugnet.cad.mlcad)
|
| |
| | Re: Parts as volumes (instead of surfaces)
|
|
(...) So stud4 would be decomposed into 16 trapezoidal prisms? That sounds like a fair amount of mark up. (...) Nod, true. But I'd rather decompose a 1x1 brick into 6 volumes (4 walls, 1 top and the stud) than 46 (one volume for each surface (...) (23 years ago, 10-Apr-02, to lugnet.cad.dev.org.ldraw)
|
