 | | Re: L3PAO Floor Problem
|
|
(...) I've experienced this same problem. As Gary correctly points out in another reply, the floor is infinite, but it's possible to position the camera so low relative to the floor that the floor slices through the "lens" of the camera; since (...) (23 years ago, 20-Nov-01, to lugnet.cad.ray)
|
| |
| | Re: Rendering Problems
|
|
(...) Oh! OH! I know this :-) There's a drop-down box in the left-hand corner just under the toolbar. Pull that menu down and select another image resolution. HTH, Will Bricksburg Fire Department: www.bricksburg.org GoB Bricksburg Depot: (URL) (23 years ago, 20-Nov-01, to lugnet.cad.ray)
|
| |
| | Re: Rendering Problems
|
|
I reinstalled L3P and Pov-Ray and most everything is back to normal. I can actually render a .pov file now. However, it is rendering in a *very* small window. Previously, the renderings took up the entire screen. How can I change this? -Kyle (...) (23 years ago, 20-Nov-01, to lugnet.cad.ray)
|
| |
| | Re: New Part: dome.dat (and a part authoring tool idea)
|
|
(...) You can see the missing upper dome lines here. (URL) there seem to be some type 2 lines that should perhaps be type 5 lines on the undersides of some of the technic pin sockets? You can see a few on the top left part of the picture. Don (23 years ago, 20-Nov-01, to lugnet.cad.dat.parts, lugnet.cad.dev)
|
| |
| | Completed 2484?
|
|
I am looking for a DAT file for part 2484. I found this file on LUGNET from a couple of years ago. (URL) DAT file appears to be incomplete as it is just the top of the sprint axel assembly. Is there a complete version somewhere? Here is a picture of (...) (23 years ago, 20-Nov-01, to lugnet.cad.dat.parts)
|
