|
|
 | | Re: Demo of part manipulation in isometric view
|
| (...) Nice interface. Like it! I was wondring if you planned to rlease the source code... (GPL of course?) as I was considering a similar interface for a different (non-lego) program... (...) (23 years ago, 31-May-01, to lugnet.cad.dev)
| | | | | MOTM Parameters question
|
| Is there any requirement that LDraw/rendered submissions use only "official" part/color combination, or that they use only "official" LCad DAT parts? I wouldn't presume to submit any clone parts, of course, but there are some canonical parts, such (...) (23 years ago, 31-May-01, to lugnet.cad.dev.org.ldraw)
| | | | | Re: Differences between rotation points
|
| (...) from (...) library (...) rotation (...) That helps a lot. Thanks! Cheers, --Ryan (23 years ago, 30-May-01, to lugnet.cad.dev, lugnet.cad.mlcad)
| | | | | Re: Maximum Coarse movement
|
| (...) Shure, I will take care on that. In the mean time you could move the part using the mouse and a small scale factor in the viewing pane. That should help a little bit. Michael (23 years ago, 30-May-01, to lugnet.cad.mlcad)
| | | | | Re: Differences between rotation points
|
| (...) - Part Origin, is the absolute zero (0,0,0) point of the part itself. - Part Center, is the computed center of the part (e.g. the part ranges from (-2, -2, -2) to (+4, +4, +4) so the computed center is (+1,+1,+1). - The part rotation point, is (...) (23 years ago, 30-May-01, to lugnet.cad.dev, lugnet.cad.mlcad)
|
|
