 | | Re: We need an update NOW (Was: Parts Update?)
|
|
(...) This would work. Just don't take Steve off of the new system -- with him working on it, it's gonna be good. Cheers, - jsproat (24 years ago, 1-May-01, to lugnet.cad.dev, lugnet.cad.dev.org.ldraw)
|
| |
| | Re: We need an update NOW (Was: Parts Update?)
|
|
"Fredrik Glöckner" <fredrik.glockner@bio.uio.no> wrote in message news:qrd1yq98itn.fsf....uio.no... (...) Its not a matter of hiding the work, see below. (...) This is the case. Newsgroup discussions get noisy - people tend to have long drawn out (...) (24 years ago, 1-May-01, to lugnet.cad.dev, lugnet.cad.dev.org.ldraw)
|
| |
| | Re: We need an update NOW (Was: Parts Update?)
|
|
"Chris Dee" <chris_w_dee@hotmail.com> wrote in message news:GCnMwn.Axw@lugnet.com... (...) Disagree. We package the parts and put a whoppin disclaimer on them. They are not official, just compiled and made easily available. We make it clear that (...) (24 years ago, 1-May-01, to lugnet.cad.dev, lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Will not run
|
|
(...) LDRAW is a command-line program. To use it, you would normally go to a DOS prompt, cd to c:\ldraw, and type LDRAW mymodel.dat. But that's just to render a model. To create a model, you need to use an editor like LEdit (comes with LDraw) or (...) (24 years ago, 1-May-01, to lugnet.cad)
|
| |
| | Re: We need an update NOW (Was: Parts Update?)
|
|
"Chris Dee" <chris_w_dee@hotmail.com> wrote in message news:GCnMwn.Axw@lugnet.com... (...) I've only done one part so far and I've had just 4 comments (1 on an "almost done it" post, 2 on a "done it but no optional lines yet", and 1 by private (...) (24 years ago, 1-May-01, to lugnet.cad.dev, lugnet.cad.dev.org.ldraw)
|
