|
|
 | | New Part : Spyrius Torso [DAT]
|
| So why did I leave this lying around on paper for so long ? Here it is - LMKWYT Chris 0 FILE 973p66.DAT 0 Minifig Torso with Spyrius Pattern 0 Name: 973p66.dat 0 Author: Chris Dee (chris_w_dee@hotmail.com) 0 Unofficial Element 4 16 12 0 10 -12 0 10 (...) (24 years ago, 9-Jun-00, to lugnet.cad.dat.parts)
| | | | | ldglite dev version questions
|
| Since the ldglite web page says to post questions/etc. here, here I am... Trying to compile a Linux version from the dev release on sourceforge (ldglitesrc0_6pre8.zip) has been a dismal failure - numerous undefined types, etc. Is this a (...) (24 years ago, 9-Jun-00, to lugnet.cad.dev)
| | | | | Re: Modelling !
|
| (...) Some of this has come up in various discussions. I'm not sure if all of it has or not. (...) No, centering on a stud isn't necessary. Look at 3001.dat, the 2x4 brick. It is centered on X-Z, not on a stud. The same applies for all other (...) (24 years ago, 9-Jun-00, to lugnet.cad.dev)
| | | | | Re: Modelling !
|
| (...) Thanks ! So, 1.00 mm = 2.5 LDU (...) I call this common sence, which I think everyone should use ! (...) Are these your opinions only, or is assumed buy other people too ? I agree with most of it ! (...) Check! (...) Check! (...) Shouldn't we (...) (24 years ago, 9-Jun-00, to lugnet.cad.dev)
| | | | | Re: Modelling !
|
| (...) I believe the conversion is 0.4mm = 1 LDU. At least, that's what I always use. (...) Standards are already there. They just aren't strictly enforced. As I see it, there are two basic "orientation rules": 1. Do the same thing as other, similar (...) (24 years ago, 9-Jun-00, to lugnet.cad.dev)
|
|
