 | | Re: MLCad Suggestions
|
|
(...) Gestural activation is way different than true modal operation - there is no additional interface component (the "specification of operation" is part of the operation itself) and there is no state change either before or after the operation. (...) (25 years ago, 21-Feb-00, to lugnet.cad.mlcad)
|
| |
| | 3D Modeling
|
|
Hello, At this moment I am drawing (Technic) Lego parts in a 3D CAD program. The advantage of this program is that you can easy visualize the working of you model. (e.g. when you make a motor and turns the crank axle, the pistons will be go up and (...) (25 years ago, 21-Feb-00, to lugnet.cad)
|
| |
| | Re: Help! - MLCAD won't read 754.dat
|
|
The problem is in the dat file itself, due to another problem in MLCad it is reported as if it would not exist. The file 754.dat contains some illegal character-combinations in the lines 29 and 30. Both start with "01" instead of "0" or "1". The (...) (25 years ago, 21-Feb-00, to lugnet.cad.mlcad)
|
| |
| | Re: Minifig Thermos Bottle(?) - Help Needed! [DAT]
|
|
(...) How does it hate you? (...) See below. (...) Not me. (...) No, because Thermos™ is a trademark (I admit, I didn't go do a search. But I'm 99.99% sure). Steve 0 @Minifig Thermos Bottle 0 Name: 0 Author: Tore Eriksson 0 Un-Official Part 0 (...) (25 years ago, 21-Feb-00, to lugnet.cad.dat.parts)
|
| |
| | Re: 32191.dat and request photo of Technic Panel #3 and #4 (32188)
|
|
(...) This not the best way to proceed. It is better to use 3-8cyli.dat instead, and then hard-code the last polygon (or two), based on the polygons from 1-4cyli.dat. But the approach you describe has been used on some parts. Steve (25 years ago, 21-Feb-00, to lugnet.cad.dat.parts)
|
