Subject:
|
Re: Storm drain puzzle / Keep Them Rolling
|
Newsgroups:
|
lugnet.build.vignette
|
Date:
|
Fri, 30 Jun 2006 07:01:25 GMT
|
Viewed:
|
6104 times
|
| |
|
|
In lugnet.build.vignette, Manfred Moolhuysen wrote:
| |
Hello All,
First, a small quiz for you lot: Can you figure out what parts I’ve used to
build the inlet grating of the storm drain seen in the following picture? And
how I’ve attached those and the lid of the drain?
|
Hinge Bar 2 & 1/2 with 2 and 3 Fingers on
Ends
-jeremy
visit: gplr
|
|
Message has 1 Reply:
 | | Re: Storm drain puzzle / Keep Them Rolling
|
| (...) on Ends> Well spotted, Jeremy. If you have these parts, try to build one. The half plate difference in height doesn't allow for the lid to be fixed with a stud connection. The lid is held on place against vertical motion by a "tail"-plate (...) (18 years ago, 30-Jun-06, to lugnet.build.vignette)
|
Message is in Reply To:
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
