Sculpture : 521


Building / Sculpture / 521	520 \| 522

Subject:	Re: New MOC: Sphere (6.8 Stud Diameter)
Newsgroups:	lugnet.build.sculpture
Date:	Thu, 17 Jul 2003 21:54:26 GMT
Viewed:	1011 times

I looked at this a while back, then saw the one at LLCA, then I decided I’m going to build a building that had tan Domes on the top, with smaller cone sticking out of the top (not gonna say what its for, its a secret), But there were no useable parts. Then I happened across you post again! This is conna be perfect for it, on the bottom, the one brick 2 plate, does it line up well with the halfway point of the sphere? Josh

Message is in Reply To:

		New MOC: Sphere (6.8 Stud Diameter)
Hey guys, I finally put up my 6.8 stud diameter sphere that I've had sitting on the backburner for ever. Check it out here: (2 URLs) Any feedback is welcome and encouraged. Thanks a lot. Oh, instructions (picture and LDraw) are available through the (...) (21 years ago, 2-Jun-03, to lugnet.announce.moc, lugnet.build.sculpture, lugnet.inst, FTX) !

10 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search