| |
In lugnet.announce.moc, Erik Amzallag wrote:
[snip]
| |
I wasn’t really satisfied with this solution. The coming of the panel 3x3x6
corner in white in the #7635 set brings a new solution.
8 of them make a really nice tank.
|
[snip]
[snip]
Nicly done, and good proportions in relation to the tank.
If I spot correctly the trick of the inside structure is 2x part #60474 Plate
Round 4 x 4 with Pin Hole, that are placed back to back, joined by an axle and
2x part #3713 Technic Bush. The cutouts on one of the rims of the Technic Bush
fit between the studs of the plate and prevent these from turning.
| |
The inside structure is enough strong (but probably not for a kid).
|
I might have a suggestion to improve this a bit. I think it’s possible to
strenghen the inside structure by using a longer axle, 2x part
#3709b Technic, Plate 2 x 4 with 3 Holes
instead of the plain 2 x 4 ones, and by replacing some of the Bricks 2 x 2 with
parts #6232 Brick 2 x 2 with Pin and
Axlehole
With friendly greetings, M. Moolhuysen.
|
|
Message has 1 Reply:
 | | Re: Tank truck
|
| (...) Thanks. (...) That's correct. (...) It's a possibility. But not sure it will strengthen the structure, as the main issue is that the panels are only connected by the 4 top studs. Just waiting for a 6x6 round plate now :) Erik (16 years ago, 31-Mar-09, to lugnet.town, lugnet.build.schleim, FTX)
|
Message is in Reply To:
| | Tank truck
|
| Hello, The difficulty with the minifig-sized tank trucks is to get a 6-wide tank. One of the solutions is to use 6x6 round dishes ( (URL) for instance, like Pierre Normandin did> ) I wasn't really satisfied with this solution. The coming of the (...) (16 years ago, 30-Mar-09, to lugnet.announce.moc, FTX) !
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
