Subject:
|
Re: MOC: Willys Jeep with variations
|
Newsgroups:
|
lugnet.build.military
|
Date:
|
Wed, 22 Jan 2003 23:00:19 GMT
|
Viewed:
|
3366 times
|
| |
|
|
In lugnet.build.military, Constantine Hannaher writes:
> However, I was unable to figure out how the fenders get right under the hood
> like that, so the fenders of my imitation are one plate below.
Thanks Constantine and Bill for showing interest in my little models.
To the weekend I will make an ldraw picture explaining the fender mounting
(2x1 panel + 1x1 corner panel fixed to a 1x3 plate mounted on the side of a
1x2 technic brick with 2 holes)
Bill you liked the girl jeep with a larger engine under the hood. It is also
the favourite among the females at my work. Horse-power impress :-)
Otherwise the hood should be kept low and flat to be true to the original
Willys Jeep as Constantine mentions. I will test to add lamps, and try to
make some more colour schemes.
Mattias
|
|
Message has 1 Reply:
 | | Re: MOC: Willys Jeep with variations
|
| For some reason I was stuck on using the 1x2 brick with tilt top! Thanks for the hint, but I find that placing the panels a plate lower brings them in line with the headlights rather than above them and have found the effect congenial while not (...) (24 years ago, 23-Jan-03, to lugnet.build.military)
|
Message is in Reply To:
| | Re: MOC: Willys Jeep with variations
|
| I wonder, Bill, if you are thinking of the civilian CJ series. This MOC is of the military Jeep, where I do believe the flat hood is prototypical. This also explains the low door and high back, which is opposite to the arrangement on current (...) (24 years ago, 22-Jan-03, to lugnet.build.military)
|
14 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
