Subject:
|
Re: Deathscythe Hell Buster Shield
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Sat, 10 Aug 2002 03:37:28 GMT
|
Viewed:
|
665 times
|
| |
|
|
In lugnet.build.mecha, Josh Opotzner writes:
> In lugnet.build.mecha, Borislav Marinov writes:
> > Deahtscythe Hell?s Buster Shield (together with the 1/100 version)
> > Measuring 43 x 26 cm (that?s about 16.5 by 10.5 inches)
> >
> > http://www.brickshelf.com/cgi-bin/gallery.cgi?f=22723
>
> Excellent job on the Buster Shield, Bobby. May I ask what sort of
> joints/hinges each of the two halfs employ to open out?
> --Josh
Thanks for the compliment! I thought of using a left-right horizontal click
hinges, but those are too big. The start system horizontal hinges are too big
also, and I have only 3 of the 1/3 tall hinges and 2 of them are already in use
:( So, there are no hinges. The last stud in the near corner of the "blade"
is attached to the shield on several places through the vertical axes
(connections stacked on top of each other). Very primitive but there is
actually enough friction to hold things in place.
Have fun!
Bobby (Neue-Oz)
|
|
Message is in Reply To:
 | | Re: Deathscythe Hell Buster Shield
|
| (...) Excellent job on the Buster Shield, Bobby. May I ask what sort of joints/hinges each of the two halfs employ to open out? (...) Whooo yeah :) I saw a commercial for it yesterday as well. We finally have a Gundam series again!! :) Toonami has (...) (22 years ago, 6-Aug-02, to lugnet.build.mecha)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
