Subject:
|
Ball joint strengthener
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Fri, 21 Jun 2002 04:04:11 GMT
|
Viewed:
|
281 times
|
| |
|
|
I don't know if this has already been discused or not, as I'm new here,
but I think (think) I have a way to strengthen hip (and possibly other)
joints created by ball joints. (Note: I have not tried this so I do not
know if it will work at all.) Anyway, I believe that if you took a
technic flex hose and shoved it through you mech's leg at point "A1" (see
super corny diagram below) and bent it down and thrust it through the
waist at point "B" and then bent it back upward and pulled it through the
other leg at point "A2" you could strenghthen the hip joints by quite a
lot. the whole philosophy that I have is that if you have something else
that unversely bends and is tougher or as tough as (not as willing to
bend) the ball joints then you could strengthen them quite a bit. Once
again I have no idea if this will work or not, I have not tried it.
Though, I would appreciate it if all of you would give me some feedback
on this idea and maybe even try it too!
Thanx!
And, of course,
May the Brick be with you!
* Tim *
Super Corny Diagram:
__ ___ __
/A1 /=| |=\ A2\
/ / | B | \ \
/ / UU \ \
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit:
http://dl.www.juno.com/get/web/.
|
|
Message has 1 Reply:
 | | Re: Ball joint strengthener
|
| Woah! I think I understand what your getting at, but you confused me with all the A1 A2 stuff, :-P Cool idea tho bud, pics pics pics -Geordan- (...) (22 years ago, 21-Jun-02, to lugnet.build.mecha)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
