Subject:
|
Re: 3 New Mecha
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Wed, 30 May 2007 02:22:26 GMT
|
Viewed:
|
10297 times
|
| |
|
|
In lugnet.build.mecha, Jon Walden wrote:
| |
In lugnet.build.mecha, Eric Sophie wrote:
| |
In lugnet.build.mecha, Jon Walden wrote: • -snip-
|
Thanks !
| |
I was wondering, I guess you rely on the sole rotaional (non-friction) of the
4x4 turntable in the waist pivot. Had you considered using one of those micro
motor mounts (with rubber insert) along with a 3L axle w/stud (and a 2x2
round plate) to create a measure of friction in that joint? Give it a try.
Though you will have to raise the height around that joint to incorporate the
components. Just an idea.
|
I’m not sure what pieces you’re talking about, Eric. Could you post some pics
for me?
|
See the lt. gray part on the left:
When you use that set up it helps add friction to joints like this:
Or maybe you can use a technic ball joint for it’s rotational friction next time
you try a similar set up if you want.
Either way I liked seeing what you made. Thanks!
-snip-
|
|
Message is in Reply To:
 | | Re: 3 New Mecha
|
| (...) Snip (...) Thanks ! (...) I'm not sure what pieces you're talking about, Eric. Could you post some pics for me? (...) snip (...) snip (...) (17 years ago, 30-May-07, to lugnet.build.mecha)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
