Subject:
|
Re: New Joint Tech
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Sat, 14 Feb 2004 12:47:18 GMT
|
Viewed:
|
546 times
|
| |
|
|
In lugnet.build.mecha, Soren Roberts wrote:
| |
Not much else to say about it. Approximates the human knee joint disturbingly
well. It bends further than the picture shows, so build one and experiment!
Enjoy!
Soren
|
Interesting... Is that black peice in the center a tire? It’s kindah hard to
tell... This could work pretty well with small mecha.
-Mark
|
|
Message has 2 Replies:
 | | Re: New Joint Tech
|
| small mecha, sure, but think of the implications for transforming mecha! a bendable knee joint? the would give a lot of manuverablity to the cmpacting actions required in the feild of transforming mecha... (21 years ago, 14-Feb-04, to lugnet.build.mecha, FTX)
| | | Re: New Joint Tech
|
| (...) Yeah. I thought it was pretty clear, but apparently not... (...) Larger mecha too, if you mounted two side-by-side. Soren (21 years ago, 14-Feb-04, to lugnet.build.mecha)
|
Message is in Reply To:
| | New Joint Tech
|
| Not much else to say about it. Approximates the human knee joint disturbingly well. It bends further than the picture shows, so build one and experiment! (URL) Enjoy! Soren (21 years ago, 13-Feb-04, to lugnet.build.mecha, FTX)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
