Subject:
|
Re: How do you do this? Doors and roofs?
|
Newsgroups:
|
lugnet.build.arch
|
Date:
|
Wed, 6 Oct 2004 09:22:10 GMT
|
Viewed:
|
4732 times
|
| |
|
|
I send this to lugnet.build.arch too, hope to get some input.
The most important right now, is to get to know more about odd roofs, where e.g.
walls are not straigh.
Sonnich
In lugnet.build, Sonnich Jensen wrote:
> 1: DOORS
> Working with the 6105 doors, http://peeron.com/inv/parts/6105 , I do not want to
> have the bricks 90 degrees on as normally,but in a line - so the door is fixed
> in the middle of the stud, not close to the wall.
> This requires some very odd offset from the wall (wall - offset - door holder -
> door - and the same on the other side) - to make the door look normal.
> Have anyone done this?
> How do you achive such an offset?
>
> 2: ROOFS
> I was playing around with walls, and found that a 3x4 sizes squere, gives a nice
> almost 45 degree wall of 5 studs (as the power of 5 = power of 3 + power of 4),
> but creating a roof for that?
> I was thinking of normal 45 degrees slopes, but the turned wall?
> I am open for other solutions, was thinking of plane wings, but that does not
> seem as a good idea.
> Anyone tried this?
|
|
Message is in Reply To:
 | | How do you do this? Doors and roofs?
|
| 1: DOORS Working with the 6105 doors, (URL) , I do not want to have the bricks 90 degrees on as normally,but in a line - so the door is fixed in the middle of the stud, not close to the wall. This requires some very odd offset from the wall (wall - (...) (20 years ago, 4-Oct-04, to lugnet.build)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
