To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.buildOpen lugnet.build in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Building / 950
949  |  951
Subject: 
Re: 1x1 round plates in station
Newsgroups: 
lugnet.build
Date: 
Wed, 10 Mar 1999 22:15:22 GMT
Viewed: 
891 times
  
1x1 Round Plates first appeared in 1980, quite a bit before 1990.  1990
is about the time that they started to be separated from sprues,
though.  Originally, they all came on sprues.

The first use of them was as headlights for Trains.  They were round as
the stud fit into a recess in a support brick that held the light prisms
that separated one light source into two headlight outputs (this was for
the 12v Trains).  Standard plates could have been used (I suppose), but
they wouldn't have looked very good.  The next year, 1981, they were
introduced into Town System and Space System sets.

Actually (according to the catalogs - I've not seen it in person, and
always wondered how well it worked), the prism had a taller stud that
would go through the hole in the support brick and stick out like
a regular stud, onto which the round plates were then put.
...I just realized (never did before) that without the round plate
(for lack of clear round or 1x1 plates), this would still have
made for a nice headlight set for a 6-wide car.
(Rear-engined, though, as that support brick takes up a grille's
space - though one could have put 1x1-recessed-side-stud pieces
in front of the lights, again with 1x1 clears on them for headlights,
and then put grille material in between.)

-gbr



Message has 2 Replies:
  Re: 1x1 round plates in station
 
(...) It works pretty well ;) Jasper (26 years ago, 11-Mar-99, to lugnet.build)
  Re: 1x1 round plates in station
 
(...) Ouch, yes. That's embarassing. Teaches me to speak from memory. You are indeed correct (I'm going from brochure photos as well, but the 1981 German Trains brochure shows it very well). The prism held the round plates, rather than the holes in (...) (26 years ago, 12-Mar-99, to lugnet.build)

Message is in Reply To:
  Re: 1x1 round plates in station
 
(...) 1x1 Round Plates first appeared in 1980, quite a bit before 1990. 1990 is about the time that they started to be separated from sprues, though. Originally, they all came on sprues. The first use of them was as headlights for Trains. They were (...) (26 years ago, 10-Mar-99, to lugnet.build)

8 Messages in This Thread:




Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR