Subject:
|
Re: How to get apart that structure?
|
Newsgroups:
|
lugnet.general, lugnet.build
|
Date:
|
Wed, 28 Mar 2001 13:05:27 GMT
|
Viewed:
|
139 times
|
| |
|
|
Hi Andy,
In lugnet.general, Andy Lynch writes:
> Ouch.
> My first thought was that you could push the axles through, but looking • closer,
> I see those are axle connectors, and so those are two length 3 axles, not one
> length 6 axle. So, the axles cannot be pushed through them.
That's the point! The axle connectors makes it impossible to push the axles
through the whole strcture!
> Hmmm.
>
> It looks to me that only thing that may get it apart is the fact that • sometimes
> the bricks flex a little bit, so you could try to push in opposite directions
> on the horizontal 1 x 6 beams and try to pry out one of the plates that are on
> the cross beam in the middle. If you manage that, then you should be able to
> do the same on the other side and take the cross beam out. Then it would just
> fall apart.
That is a solution, but does that idea fit the regular way of putting LEGO®
apart?
> Looks like it's going to be tough.
Ohh, yes - but even constructing something like that must have been very tough,
or just coincidence?
Regards,
Holger
|
|
Message has 3 Replies:
 | | RE: How to get apart that structure?
|
| (...) Whenever I use Technic beams and pins in a construction, I end up having to flex parts to put things together and take them apart...which is a real pain when you're trying to improve some little thing. --Bram Bram Lambrecht bram@cwru.edu (URL) (24 years ago, 28-Mar-01, to lugnet.general, lugnet.build)
| | | Re: How to get apart that structure?
|
| Hi Holger, ----- Original Message ----- From: "Holger Matthes" <matthes@fh-aachen.de> (...) <snip> (...) directions (...) on (...) to (...) just (...) tough, (...) I agree the method that I described is a bit un-Lego, but my interest was in (...) (24 years ago, 28-Mar-01, to lugnet.general, lugnet.build)
|
Message is in Reply To:
| | Re: How to get apart that structure?
|
| Ouch. My first thought was that you could push the axles through, but looking closer, I see those are axle connectors, and so those are two length 3 axles, not one length 6 axle. So, the axles cannot be pushed through them. Hmmm. It looks to me that (...) (24 years ago, 28-Mar-01, to lugnet.general, lugnet.build)
|
29 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
