 | | Re: Analogue Control of Pneumatics —Alvin Telanco
| | | | (...) Ok. So you can't do it with pneumatics. Looking around for alternative ways of making a power steering mechanism, I found this link (URL) which gives an RCX based motor driven mechanism that might be of interest to others. Al Telanco (24 years ago, 22-Mar-01, to lugnet.build, lugnet.general, lugnet.technic, lugnet.robotics.rcx)
| | | | | | | | | | Re: Analogue Control of Pneumatics —Ross Crawford
| | | | | | (...) I wouldn't say that at all. Its just that you'd need a good supply of compressed air (there's plenty of compressor designs about) and a good feedback mechanism. This is by no means impossible - just a bit tricky. ROSCO trimmed lugnet.general (...) (24 years ago, 22-Mar-01, to lugnet.build, lugnet.technic, lugnet.robotics.rcx)
| | | | | | | | | | | | Re: Analogue Control of Pneumatics —Jason S. Mantor
| | | | | Whoa. Not entirely correct. You can do accurate positioning with pneumatics, it's just harder to do than with hydraulics, because you have to take air compressiblity and seal "stiction" into account if you want to hit an arbitrary position that's (...) (24 years ago, 22-Mar-01, to lugnet.build, lugnet.general, lugnet.technic, lugnet.robotics.rcx)
| | | | | | | | | | | | Re: Analogue Control of Pneumatics —Mike McFarlane
| | | | | Hi I did some 'research' in this area about three years ago for the control of a pneumatic robot arm. It was quite simple positional control ie position the piston at any point in the cylinders stroke and hold it there. The controller was just a PC (...) (24 years ago, 24-Mar-01, to lugnet.build, lugnet.general, lugnet.technic, lugnet.robotics.rcx)
| | | | | | | | | | | | Re: Analogue Control of Pneumatics —Jason S. Mantor
| | | | | Yep, and if you combine those high-speed, high-precision pressure regulators with low stiction cylinders and a fast PID controller you can get even better accuracy and repeatability. When I was working for an encoder company, I scavenged some parts (...) (24 years ago, 25-Mar-01, to lugnet.build, lugnet.general, lugnet.technic, lugnet.robotics.rcx)
| | | | | | | | | | | | Re: Analogue Control of Pneumatics —Geoffrey Hyde
| | | | | Perhaps TLG should be meeting companies that produce valves of the same quality as those mentioned. It also sounds like the timing belt used for the test bed could be replaced or reinforced even more. -- Cheers ... Geoffrey Hyde "Xanthra47" (...) (24 years ago, 25-Mar-01, to lugnet.build, lugnet.general, lugnet.technic, lugnet.robotics.rcx)
| | | | | | |
