 | | Two Design Problems
|
| I am having a hard time solving two design problems related to the base I am building. Problem 1: I want to use a single motor to (slowly) raise a vertical shaft (e.g., a Technic axel mounted vertically) 8 to 16 studs. After raising the shaft to (...) (24 years ago, 7-Nov-00, to lugnet.build)
| | | | | Re: Two Design Problems
|
| (...) I would mount your rotating axle on an upright micro-motor. Then, stand the micro-motor on a base which you raise and lower. The axle could go up through a hole in a technic plate if you want to hide the mechanism underground. This brings us (...) (24 years ago, 7-Nov-00, to lugnet.build)
| | | | | Re: Two Design Problems
|
| Damraska skrev i meddelandet ... (...) Not tested at all, just an idea, sorry for my lack of English: Use a worm drive (is that the right word for the 'screw' gear?) and straight cogged pieces (word?) to do the raising. When the cogged pieces are (...) (24 years ago, 7-Nov-00, to lugnet.build)
| | | | | Re: Two Design Problems
|
| Jason J. Railton <j.j.railton@cwcom.net> wrote in message news:G3nots.9z9@lugnet.com... (...) am First off, thanks for the input. I appreciate it. (...) the (...) The only problem with this is that, assuming I power both motors simultaneously, the (...) (24 years ago, 9-Nov-00, to lugnet.build)
| | | | | Re: Two Design Problems
|
| Anders Isaksson <isaksson.etuna@REMO...tninet.se> wrote in message news:G3oBM1.4MI@lugnet.com... (...) to (...) motor (...) lowers (...) straight (...) to (...) a (...) is, (...) Anders, that's perfect. Your mock-up is similar to what I already (...) (24 years ago, 9-Nov-00, to lugnet.build)
| |
