Subject:
|
Re: Container grabber
|
Newsgroups:
|
lugnet.build, lugnet.trains
|
Date:
|
Thu, 20 Jan 2000 12:00:09 GMT
|
Viewed:
|
1978 times
|
| |
|
|
In lugnet.build, Allan J. Smith writes:
> The grabber I made is designed to lift my 6 wide piggyback trailers
> as seen on my webpage. (it will also lift 4 wide trailers).
>
> It uses L shaped 2x2 plates in the 4 holes of the red grabber.
> Attached to the outside of the plates is a 8x1 block. On the
> ends are a 2x1 plate hinge. These are angled at 90 degress
> down to which is fitted a 8x1 plate. On the inside end of the
> plate is a 1x1 round plate. These fit automatically under the
> trailer body when it reaches the bottom of the trailer sides.
>
> The overhead crane matches the 4555 crane but uses 2
> yellow ends rather than the red building.
>
> I will try and get some photos of it soon.
>
> Allan
Please do show us some detailed photos. The overhead crane is in need of a
design impovement to make it useful (able to pick up piggyback trailers).
Jim
---
|
|
Message is in Reply To:
 | | Re: Container grabber
|
| The grabber I made is designed to lift my 6 wide piggyback trailers as seen on my webpage. (it will also lift 4 wide trailers). It uses L shaped 2x2 plates in the 4 holes of the red grabber. Attached to the outside of the plates is a 8x1 block. On (...) (25 years ago, 20-Jan-00, to lugnet.build, lugnet.trains)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
