Subject:
|
Building a "Teddy Bear"
|
Newsgroups:
|
lugnet.build
|
Date:
|
Thu, 16 Dec 1999 09:56:56 GMT
|
Viewed:
|
988 times
|
| |
|
|
I just posted suggestions for building a "Teddy Bear" on the
Nordic groups. I thought I would share them with the
foreigners:
[ Warning: untested design ]
* Start with a stack of two 2*2 plates.
* Add a 1*2 plate on top.
* Put a 1*2 plate with a single knob on top of that.
* Then a 1*1 brick with knobs on all four sides.
* Put a 1*1 plate on two of the previous brick's side knobs
(so it is almost as wide as the 1*2 plates below).
* Add a 1*2 plate to each of the two 1*1 plates from the
previous step (they should point in the same direction as
the 2*2 plates).
* Add a 1*1 plate on top of the 1*1 brick.
* Finalise the bear with a head.
I would build it in red or yellow, but people can of cause
choose whatever colour they like.
Play well,
Jacob
------------------------------------------------------------
-- E-mail: sparre@cats.nbi.dk --
-- Web...: <URL: http://hugin.ldraw.org/LEGO/Dyr/ > --
------------------------------------------------------------
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
