To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.buildOpen lugnet.build in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Building / 1654
  Re: new (to me) use for worms
 
(...) If I'm understanding the workings, what is being suggested is to use the worm as a slip coupling (which just happens to have a worm screw). If you look at a cars drive shaft, you will see that it is in two parts so that it can change length. (...) (25 years ago, 18-Jun-99, to lugnet.build)
 
  Re: new (to me) use for worms
 
(...) Yes. (...) I did not know that. I've accepted over time that a number of things in car suspensions must work simply by having room to wiggle a bit, but that this particulalr problem is avoided *that* simply explains a lot. (Wait till you see (...) (25 years ago, 18-Jun-99, to lugnet.build)
 
  Re: new (to me) use for worms
 
(...) I've been up close and personal to a drive shaft. I had an old Chevy van which liked to get into 2nd & reverse at the same time (fortuanately always while stopped - because the vehicle will not go ANYWHERE in this condition, if it happened at (...) (25 years ago, 18-Jun-99, to lugnet.build)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR