Subject:
|
Re: glue LED bulb to brick
|
Newsgroups:
|
lugnet.build
|
Date:
|
Tue, 13 Jun 2006 18:37:31 GMT
|
Viewed:
|
3869 times
|
| |
|
|
In lugnet.build, Miles Gentry wrote:
> What glue will hold a LED bulb to a hole drilled in a brick? ABS glue from Ace
> Hardware does not stick to the bulb.
Try epoxy resin. It is a 2-part glue found at almoast any hardware store. It
should do the trick.
Most LEDs are slightly tapered. Are you using a T 1 3/4" (5mm), or a T1 (3mm)
LED? Have you tried drilling a hole slighly smaller than the LED, and then
forcing it into the hole and relying on friction to hold it in place?
---Will Chapman • BrickArms LLC
|
|
Message is in Reply To:
 | | glue LED bulb to brick
|
| What glue will hold a LED bulb to a hole drilled in a brick? ABS glue from Ace Hardware does not stick to the bulb. (18 years ago, 13-Jun-06, to lugnet.build)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
