Subject:
|
Re: Ribbed panel construction idea
|
Newsgroups:
|
lugnet.build, lugnet.trains
|
Date:
|
Thu, 25 Mar 2004 12:51:03 GMT
|
Viewed:
|
1473 times
|
| |
|
|
In lugnet.trains, Tim David wrote:
| |
While working out how to do the ribbed sides common on many modern locomoives
I hit upon using this
part
After a
serious of experiments to get the offset right I eventually came up with this
design
...
|
It’s an interesting idea. You could alternate 5-studded ‘dalek’ bricks with
1-stud technic ‘tumble-dryer’ bricks along the centre line.
Have you tried building this for real yet though? I thought that all the 1x2
plates with handles had at least some droop to the side bars, which isn’t shown
on this CAD piece. That would cause problems if you use a combination of them
right-way up and upside-down.
Jason Railton
|
|
Message has 2 Replies:
 | | Re: Ribbed panel construction idea
|
| (...) I had thought that, t would reduce the rare piece count but would reduce the strength (actually it reduced it in one direction and increase it in another, hmm does it even need the strength there?) (...) There are two versions of this part, (...) (21 years ago, 25-Mar-04, to lugnet.build, lugnet.trains, FTX)
| | | RE: Ribbed panel construction idea
|
| There are 2 versions of the 1x2 with handles...1 is dropped by 1/2 a plate height and the other is level. -----Original Message----- From: news-gateway@lugnet.com [mailto:news-gateway...net.com]On Behalf Of Jason J Railton Sent: Thursday, March 25, (...) (21 years ago, 25-Mar-04, to lugnet.build, lugnet.trains)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
