Subject:
|
Re: LEGO Rubik Cube: significant size reduction
|
Newsgroups:
|
lugnet.build
|
Date:
|
Wed, 3 Dec 2003 19:37:34 GMT
|
Viewed:
|
1130 times
|
| |
|
|
In lugnet.announce.moc, Maarten Steurbaut wrote:
| |
When I announced my first (very large) Rubik Cube, I was very disappointed to
hear that somebody else already made a Rubik Cube (only a couple of months
before I did). Even more, Martin Howard’s Cube was smaller than mine.
I had
to try again and do better this time.
The small
version of the Rubik Cube
Hope you all like it
Maarten
|
Good work! I think that’s as small as it can go (with 3x3x3 studs the 2:5
ratio doesn’t hold). Great minds think alike - good to see some careful use
of paper - my cube would never have existed with out it!
I was curious to see that the cube starts to “explode” when being tipped
over. I’m guessing this is a result of the corner pieces not “locking” with
their neigbouring pieces. Note sure how it could be done - but I’m thinking!
Well done on miniturising again
Martin
P.S. thanks for the comments on your site
|
|
Message is in Reply To:
3 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
