Subject:
|
Re: mid-size pulley wheel ?
|
Newsgroups:
|
lugnet.technic, lugnet.build
|
Date:
|
Wed, 26 Nov 2003 15:12:40 GMT
|
Viewed:
|
225 times
|
| |
|
|
In lugnet.technic, Ray Sanders wrote:
> Does a part exist that would function as a mid-size pulley wheel for a rubber
> belt ? I can use a wedge-belt wheel (p/n 4185) for a large pulley and a half
> bush (p/n 4265) for a small pulley. I was looking for something between these
> two that has the correct groove for the rubber belt and an axle slot in the
> center. Any suggestions ?
>
> Ray
There is also the micromotor pulley nr. 2983, which does NOT have the groove
centered.
|
|
Message has 1 Reply:
Message is in Reply To:
 | | mid-size pulley wheel ?
|
| Does a part exist that would function as a mid-size pulley wheel for a rubber belt ? I can use a wedge-belt wheel (p/n 4185) for a large pulley and a half bush (p/n 4265) for a small pulley. I was looking for something between these two that has the (...) (21 years ago, 26-Nov-03, to lugnet.technic, lugnet.build)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
