| | Re: new (to me) use for worms
|
|
Just as an aside, this post made me do a double take before reading it... I was going "what?? Lego doesn't make worms, just snakes and scorpions" (25 years ago, 18-Jun-99, to lugnet.build, lugnet.off-topic.fun)
|
|
| | Re: new (to me) use for worms
|
|
(...) If I'm understanding the workings, what is being suggested is to use the worm as a slip coupling (which just happens to have a worm screw). If you look at a cars drive shaft, you will see that it is in two parts so that it can change length. (...) (25 years ago, 18-Jun-99, to lugnet.build)
|
|
| | Re: new (to me) use for worms
|
|
(...) Another axle, that's the whole trick. \\\...\\\ =====[variable gap]======== \\\...\\\ (...) View from above: o ......... -o----D------ U | | U F - and D are the rear axle incl. stiffening technic beams and the differential and attching crwon (...) (25 years ago, 18-Jun-99, to lugnet.build)
|
|
| | Re: new (to me) use for worms
|
|
(...) Interesting idea. But in thinking about it (without actually prototyping), I have a problem. You propose to use the worm on the drive axle, right? And the idea is that the worm can slide a little bit to and fro to adjust for the axles movement (...) (25 years ago, 18-Jun-99, to lugnet.build)
|
|
| | new (to me) use for worms
|
|
I recently noticed that the fact that worm gears slide freely on an axle, which I've just regarded as slightly odd, can actually be of some use; to my knowledge, it's the only part that does so while being rotationally locked to the axle. What I (...) (25 years ago, 18-Jun-99, to lugnet.build)
|